ICON Rebound 20x9 6x5.5 0mm Offset 5in BS 106.1mm Bore Double Black Wheel

Built for the Miles That Matter Off the Pavement

The ICON Rebound 20x9 wheel in Double Black brings sharp, concave styling to a 6x5.5 bolt pattern platform while quietly solving the fitment problems that plague most aftermarket wheels. ICO1820908350DB uses ICON-optimized backspacing to maximize caliper clearance, reduce scrub radius, and keep suspension travel unhindered, so the wheel looks right and functions right the moment it goes on.

Key Features

• Application specific 5 inch backspacing dials in ICON optimized fitment for reduced scrub radius
• High strength cast aluminum alloy construction rated to a 2750 pound load capacity
• Powdercoated Double Black finish resists chipping and fading from daily wear
• Six spoke concave design increases brake caliper clearance on 6x5.5 platforms
• TPMS compatible with a 106.1mm center bore for a proper hub fit
• Center cap included with every wheel for a finished factory look

Fitment Table

Specifications

What's Included

• One ICON Rebound 20x9 Double Black wheel (ICO1820908350DB)
• Center cap
• Installation instructions
• Regulatory content label

About ICON

ICON Vehicle Dynamics builds suspension systems and wheels engineered around real world off road performance. Every ICON Alloys wheel is designed with application specific dimensions that consider backspacing, caliper clearance, and suspension geometry together rather than as an afterthought, which is why ICON wheels are a common pairing with ICON suspension systems on trucks and SUVs built for daily driving, towing, and trail use alike.

FAQ

The ICO1820908350DB is a 20x9 ICON Rebound wheel finished in Double Black with a 6x5.5 bolt pattern, 0mm offset, and 5 inch backspacing. It is built from cast aluminum alloy with a 2750 pound load rating and fits a wide range of trucks and SUVs using the 6x5.5 bolt pattern.

This wheel uses a 6x5.5 inch (6x139.7mm) bolt pattern, which is common across many half ton trucks and full size SUVs.

The Rebound's application specific backspacing is designed to maximize caliper clearance, but always verify clearance against your specific brake setup before ordering, especially if a big brake kit is installed.

Yes, a center cap is included with every ICON Rebound wheel.

Yes, this wheel is compatible with factory TPMS sensors, though sensors themselves are sold separately.

The ICO1820908350DB carries a 2750 pound load rating, suitable for daily driving, towing, and off road use.

Yes, the 6x5.5 bolt pattern and offset on this wheel are compatible with 1996-2024 Toyota 4Runner and 1995-2024 Toyota Tacoma applications.

The Rebound wheel is offered in Bronze, Satin Black, Double Black, and Titanium finishes.

Yes, this product carries a California Proposition 65 warning for chemicals known to the state to cause cancer and reproductive harm.

Install Instructions

1. Confirm the 6x5.5 bolt pattern, 0mm offset, and 5 inch backspacing match your vehicle's factory specifications before mounting tires.
2. Mount and balance an appropriately sized tire onto the wheel using professional equipment.
3. Remove the factory wheel and inspect the hub and lug studs for damage or corrosion.
4. Install the ICON Rebound wheel onto the hub, threading lug nuts by hand to avoid cross threading.
5. Torque lug nuts to the vehicle manufacturer's specification using a star or crisscross pattern.
6. Install the included center cap.
7. Re-torque lug nuts after the first 50 to 100 miles of driving.

Prop 65 Warning

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.