2011-2021 Jeep Grand Cherokee Demon Window Hood

SKU: BOAW-HD11JPGC-DWF / BOAW-HD11JPGC-DWFC / BOAW-HD11JPGC-DWC

UPC: 749874076222 / 749874076239 / 749874076246

Jeep Grand Cherokee Carbon Fiber Demon Window Hood

• Molded vent ring for a cleaner look. The OEM Demon hood has no mesh vent jytst like the OEM Demon hood just a trimmed opening.
• Window comes with a white protective film (remove after install and or after painting).
• All Black Ops carbon fiber and fiberglass has clear UV gel Coat protectant finish that needs a monthly wax with a quality carnauba wax. Carbon fiber hoods are buffed to a shine, so absolutely no automotive paint. If your hood dulls from lack of care or oxidizes, no worries. Wet sand and buff and it will come right back to new condition.
• Removable clear window to keep the intake run polished. A clean run helps keep velocity up all the way to the intake box. The window creates a a water break just like the OEM Demon Hood, which has a plastic surround. This is our method of a water break and a higher air velocity on a composite hood.
• RGBW Wire runs through and out the passengers side lower corner to be wired for power. The removable window makes it easy for an RGBW LED light install. Turn on the LEDs when the hood is open or when driving down the road.
• An aftermarket RGB Light Kit can be found HERE
• All hoods require hood pins for safety reasons. Black Ops Auto Works will not be liable for any damages to the product and or the vehicle caused by not properly using hood pins HERE or being incorrectly installed
• Always Carefully Close your hood slamming or pushing hard in the center may cause damage or worse crack. Always close slowly and snap closed with two open palms one over each headlight should be a smooth snap if it dos not snap close the bump stops may be stopping the hood from closing. 

Posted by engineers of the OEM Demon hood:

"2019 Hellcat makes more power than the 2018 Hellcat because of the new hood and air induction system while the 2019 Redeye makes less power than the 2018 Demon because of the new hood and air induction system"

Fitment w/ Intakes:

• Guaranteed to fit with the OEM intake only. If you have an aftermarket intake it may need to modified.
• On after market intakes you can try spinning the coupling with sensor for clearance but this is not the case with all intakes.
• This is an aftermarket hood. Intake modification will not be guaranteed. We do not guarantee this fits any vehicle with an aftermarket intake. Any intake other than OEM is aftermarket and/or modified.
• We will not take a return if it hits your intake.

Hood Pin Option 

• These are recommended as a secondary option to the OEM Catch / D Ring 
• These are to prevent hood failure from an incorrectly adjusted bump stop and to safeguard the D Ring from failure. 
• D rings and Bump stops work together to hold the hood’s nose from bouncing and should be adjusted accordingly to stop the nose of the hood from bouncing. 
• Hood pins are not meant to replace an OEM Catch / D Ring if you want to pin your hood with no Catch / D Ring a hood pin such as a large Hotchkis pin should be run.