BRExhaust Front Pipe Kit for 1986-1987 Toyota 4Runner and Pickup

Restore the split-inlet front pipe with a direct bolt-on assembly

BRExhaust 107-0269 replaces the front exhaust pipe on the verified 1986-1987 Toyota 4Runner DLX and turbo Pickup applications. The 409 stainless-steel assembly uses two 1.5-inch bolt-on inlets and a single 2-inch outlet in the OE routing.

Key Features

• BRExhaust 107-0269 is a direct-fit front exhaust pipe assembly
• 409 stainless-steel tubing with natural finish
• Dual 1.5-inch bolt-on inlets
• Single 2-inch bolt-on outlet
• Clamps and application components included
• Catalytic converter and oxygen-sensor port not included

Fitment

Specifications

What's Included

• One BRExhaust 107-0269 front pipe assembly
• Application components and hardware supplied in the exact kit
• Catalytic converter is not included

About BRExhaust

BRExhaust, a MagnaFlow Group company, produces direct-fit replacement pipes and exhaust systems around cataloged OE dimensions. Correct year, engine, trim, and emissions configuration must be confirmed before installation.

Related Parts

• No converter or gasket is linked because each companion part must match the exact Toyota emissions configuration and flange dimensions.

FAQ

It is the exact stainless direct-fit front pipe kit for the verified Toyota applications described in the fitment and specification tables above.

The included quantity is stated in the What's Included section. Unlisted companion parts are not included.

Yes. Confirm every listed year, model, engine, position, and exclusion before ordering.

Professional installation is recommended when suspension geometry, exhaust alignment, or vehicle support is involved.

No. A different part number can change dimensions, contents, material, or vehicle application.

Inspect the mounting points, factory hardware, clearances, and every mating surface before beginning.

Warranty coverage follows the current manufacturer terms and requires correct installation and normal use.

Verify security, clearance, operation, and every manufacturer-required service check before normal use.

Installation Instructions

1. Confirm the 1986-1987 Toyota model, listed trim, OE reference, and original front-pipe routing.
2. Allow the exhaust to cool, support the vehicle safely, and inspect all retained flanges and emissions parts.
3. Remove the original front pipe without damaging retained manifolds, converter connections, or studs.
4. Compare every flange and bend before positioning BRExhaust 107-0269.
5. Install the supplied components loosely, align the pipe for clearance, and tighten to service specifications.
6. Check for leaks and contact after startup, then recheck the fasteners after the first heat cycle.

California Proposition 65 Warning: This product can expose you to chemicals including antimony oxide and other chemicals known to the State of California to cause cancer or reproductive harm. For more information, visit www.P65Warnings.ca.gov.