Brembo Xtra Front Brake Kit for 2014-2024 VW Golf and Jetta

Upgrade front service with drilled rotors and low-metallic pads

Brembo KTX4082 combines application-matched front brake rotors and pads for the supported vehicles listed below. The kit is intended to restore OE-equivalent fit, pedal consistency, and street braking behavior without mixing unrelated rotor and friction configurations.

Key Features

• Brembo KTX4082: Matched front rotor and pad package
• OE-equivalent dimensions for the listed applications
• Brembo friction material matched to the rotor configuration
• Direct replacement for stock calipers
• Street-use braking package
• Service both sides of the axle together

Fitment

Specifications

What's Included

• One exact Brembo KTX4082 product configuration
• Two matched front brake rotors
• One front axle brake pad set
• Kit hardware only where supplied in the sealed exact-part package
• Calipers, brake fluid, hoses, sensors, and unrelated axle hardware are not included unless explicitly present in the sealed kit.

About Brembo

Brembo engineers application-specific components around exact dimensions, materials, and operating requirements. Use the complete manufacturer part number and application data when matching companion parts or service procedures.

Related Parts

• No internal product link is included because related components must match the exact vehicle or engine, axle position, dimensions, and service configuration.

FAQ

It is the exact Brembo brake rotor and pad kit configuration described by the specifications and application table on this page.

Only the components listed in the What's Included section are supplied. Quantities and companion parts must be confirmed before installation.

No. Match the part number and every application, position, dimension, engine, and configuration requirement.

Yes. Suspension, engine-oiling, and brake work affects vehicle safety or engine durability and should be completed by a qualified technician.

No. Consumables, fluids, tools, and unlisted companion components must be sourced separately.

Follow the vehicle and manufacturer service procedure. Axle-side suspension and brake components are commonly inspected and serviced in pairs.

No. Finish describes corrosion, heat, or appearance characteristics; compatibility still depends on the exact configuration.

Verify fastener torque, clearances, leaks or fluid level where applicable, and correct operation before normal use.

Installation Instructions

1. Confirm the vehicle, position, application qualifiers, and Brembo KTX4082 before disassembly.
2. Review the current manufacturer and vehicle service instructions and gather all required replacement fasteners, seals, fluids, and tools.
3. Support the vehicle or engine safely and remove the original component without damaging mating surfaces, sensors, lines, or adjacent hardware.
4. Compare the new part with the removed component and verify every mount, dimension, connection, and supplied component before installation.
5. Install the part in the specified orientation and tighten fasteners in the documented sequence and torque stages.
6. Complete any required bleeding, priming, alignment, calibration, or leak check, then inspect the installation again after the initial service cycle.

California Proposition 65 Warning: Cancer and reproductive harm - www.P65Warnings.ca.gov.