View vehicle applications
Fitment notes and restrictions
Description
Add a chassis-specific crossover to a center-exit 991.2 Carrera.
Formula Z Performance 250-99219000-SS is engineered for Porsche 991.2-generation 911 Carrera, Carrera Cabriolet, Carrera 4, and Carrera 4S models produced from October 2015 through December 2019. Use the verified dimensions and installation requirements below to confirm the exact configuration before fabrication.
Key Features
- Chassis-specific routing and connection geometry
- Constant cross-sectional area through the crossover
- 316L stainless steel construction
- DMLS and SLM additive manufacturing
Fitment & Requirements
Verified application for 250-99219000-SS: Porsche 991.2-generation 911 Carrera, Carrera Cabriolet, Carrera 4, and Carrera 4S models produced from October 2015 through December 2019.
- Requires Porsche Sport Exhaust and the PSE center-exit rear bumper
- Non-PSE side-exit cars require an opposing-layout Z-Pipe instead
- Verify exhaust-tip center-to-center distance against the dimensional drawing
- Welding is required and installation is downstream of emissions components
Part Numbers & Options
- Manufacturer part number: 250-99219000-SS
- Configuration: Porsche 991.2 Carrera Center Exit Z-Pipe
Specifications
| Detail | Value |
|---|---|
| Manufacturer part number | 250-99219000-SS |
| Connection size | 2.500-inch ID |
| Material | 316L stainless steel |
| Manufacturing | DMLS and SLM additive manufacturing |
| Overall dimensions | 7.79 x 4.72 x 14.06 inches |
| Installation | Welding required |
What's Included
- One Formula Z Performance crossover
About Formula Z Performance
Formula Z Performance develops compact additively manufactured exhaust components with internal geometries intended for packaging and flow paths that conventional bent tubing cannot reproduce.
Related Parts
FAQ
What is the 250-99219000-SS?It is the porsche 991.2 carrera center exit z-pipe described on this page.
Is this a direct-fit vehicle part?Yes, only for the verified application and restrictions listed above.
What connection size does it use?It is sized for 2.500-inch ID.
What material is used?The manufacturer specifies 316L stainless steel.
What is included?One Formula Z Performance crossover is included.
Is welding required?Yes. The manufacturer specifies a welded installation.
How should compatibility be checked?Confirm the exact vehicle configuration and every listed restriction before ordering.
Does the finish require special care?Minor surface variations are normal for additive-manufactured stainless parts; clean with products suitable for stainless steel.
Installation Instructions
- Confirm that the vehicle meets every listed requirement for 250-99219000-SS before installation.
- Verify the exact part, connection size, routing, and all required clearances before cutting the existing exhaust.
- Position the component in the manufacturer-specified orientation and confirm symmetry and surrounding clearance.
- Have a qualified exhaust fabricator complete the required cutting, alignment, and welding.
- Inspect all joints, fasteners, nearby heat-sensitive parts, and clearance through the full range of vehicle movement.
- After the first heat cycle, recheck the installation for leaks, contact, or movement.




