Increase front roll stiffness with a maintenance-free 26mm bar and bushing set

H&R 70462-2 is a non-adjustable 26mm front sway bar for the listed BMW xDrive applications. The larger application-specific bar increases front roll stiffness to reduce body roll and improve steering response while retaining the factory mounting locations.

Key Features

• 26mm front sway bar for the listed BMW xDrive applications
• Non-adjustable, application-specific design
• Increases front roll stiffness to reduce body roll
• Heat-treated and shot-peened spring-steel construction
• Includes H&R urethane/Teflon composite bushings designed to operate without lubrication
• Exact H&R application is identified by manufacturer part number 70462-2
• Exact H&R application is identified by manufacturer part number 70462-2

Application details and restrictions

H&R lists this 26mm bar for the xDrive applications shown. Rear-wheel-drive models use a different front bar, and this listing does not include the matching rear bar or the front-and-rear kit. Verify model, drivetrain, body style, and year before installation.

Specifications

What's Included

• H&R 70462-2: H&R 70462-2 26mm front sway bar
• Application-specific H&R front sway-bar bushings
• Rear sway bar, end links, installation labor, and unrelated suspension hardware are not included

About H&R

H&R develops application-specific springs, sway bars, and wheel-fitment components. Its suspension products are matched to the verified vehicle configuration, axle position, dimensions, and installation requirements rather than model name alone.

Related Parts

• No related store product is linked because supporting components must be verified for the exact vehicle, engine, transmission, and current H&R configuration.

FAQ

It is front sway bar for the exact application and restrictions shown above.

This is the 26mm front sway bar for the supported xDrive applications.

No. H&R identifies this front bar as non-adjustable.

Yes. The application-specific H&R front sway-bar bushings are included.

No. H&R lists this diameter and part number for the stated xDrive applications; rear-wheel-drive models use another front bar.

No. This listing is for the front bar and its bushings only.

No. A sway bar changes roll stiffness and does not set static ride height.

H&R describes its urethane/Teflon composite bushings as maintenance-free and not requiring lubrication.

Installation Instructions

1. Confirm the exact BMW model, xDrive drivetrain, body style, year, and H&R 70462-2 package label before disassembly.
2. Read the current H&R and BMW service procedures completely, then support the vehicle at the specified lifting points.
3. Unload the front suspension as directed and remove the factory front sway bar, brackets, bushings, and related fasteners without damaging nearby lines or wiring.
4. Install the supplied H&R bushings on the new bar in the documented locations and orient the bar exactly as shown in the application instructions.
5. Reconnect the factory brackets and end links, then tighten every fastener using the BMW sequence, torque values, and required suspension position.
6. Check the bar, bushings, end links, steering, brake lines, wiring, wheels, and body for clearance through the full range of motion.
7. Road-test carefully, listen for contact or looseness, and recheck the installation according to the H&R and BMW service guidance.