H&R Sport Lowering Springs for 2023-2026 Nissan Z

Lower the RZ34 evenly while retaining everyday suspension travel

H&R 53077 is a four-spring Sport kit for the 2023-2026 Nissan Z RZ34 with the 3.0L powertrain and rear-wheel drive. It lowers the car approximately 1.0 inch at both axles and works with original-style or compatible replacement dampers.

Key Features

• Four application-specific Sport springs
• Approximately 1.0-inch front lowering
• Approximately 1.0-inch rear lowering
• Progressive-rate design
• Compatible with factory-style dampers
• Reduces ride height and body roll

Fitment

Specifications

What's Included

• Four H&R 53077 Sport lowering springs
• Dampers, mounts, bump stops, alignment parts, and unrelated hardware are not included

About H&R

H&R develops application-specific suspension springs using cold-formed spring steel and corrosion-resistant finishes. Sport Springs are designed to lower the center of gravity while retaining street-oriented ride quality.

Related Parts

• No damper or alignment component is linked because companion parts must match the exact suspension configuration.

FAQ

It is the exact four-piece Sport lowering spring set for Nissan Z described in the fitment and specification tables above.

The included quantity is stated in the What's Included section. Unlisted companion parts are not included.

Yes. Confirm every listed year, model, dimension, mounting interface, and exclusion before ordering.

Professional installation is recommended whenever suspension work, wiring, alignment, or permanent vehicle preparation is involved.

No. A different part number can change dimensions, contents, finish, or vehicle application.

Inspect the mounting area, factory hardware, clearances, and every mating surface before beginning.

Warranty coverage follows the current manufacturer terms and requires correct installation and normal use.

Verify security, clearance, operation, and every manufacturer-required service check before normal use.

Installation Instructions

1. Confirm the RZ34 application, 3.0L engine, rear-wheel drive, suspension options, and expected lowering.
2. Measure the original ride height and inspect dampers, mounts, bearings, bump stops, tires, and wheels.
3. Support the vehicle safely and remove each spring using the Nissan service procedure and approved spring equipment.
4. Install the H&R 53077 springs in the correct front and rear positions with the factory isolators seated properly.
5. Torque all suspension fasteners at the manufacturer-specified ride position.
6. Settle the suspension, verify tire and chassis clearance, and complete a four-wheel alignment.

California Proposition 65 Warning: This product can expose you to chemicals including antimony oxide and other chemicals known to the State of California to cause cancer or reproductive harm. For more information, visit www.P65Warnings.ca.gov.